• Orbit mini

    Simultaneous recording from four lipid bilayers

16.07.2015 | How to prepare membranes on the Orbit mini

Icon Orbit Mini   Orbit Mini

Short introduction how to prepare membranes on the Orbit mini (tutorial video, 16 seconds)

Guide:
Manually paint a lipid bilayer on the chip’s four cavities by gently spreading lipid solution over them with e.g. one of the provided tools for painting (brush, Teflon piece in holder, glass rod) 

Nanion recommends to paint bilayers via lipid covered air bubbles:

1. Take e.g. a 10 μl Eppendorf pipette (small white tip)
2. Cover the tip with lipids by dipping it into the lipid stock solution without aspirating any of it. Due to capillary forces a small amount of lipid solution will remain in the pipette tip - squeeze out any of these residues from the pipette tip
3. Place the tip on the chip’s surface close to a cavity, dispense a small air bubble (2-3 μl) over the cavity and aspirate it back. This results in the formation of a lipid bilayer which can be monitored by following the change in the current response: the signal should not go into saturation anymore and exhibit capacitive properties as shown on the right

Repeat step 3 on all cavities. If bilayer formation is not successful within a first run start again at step

Note: Do not throw the tip away afterwards. It can be still used to repaint broken bilayers during the experiment.

Duration of the video:
16 seconds


Playback

Back to Overview

Contact Us

Please type your full name.
Invalid email address.
Invalid Input
Invalid Input
Nanion Technologies GmbH

Ganghoferstr. 70A
D-80339 Munich - Germany
info@nanion.de